I am changing the belt to the a/c pump on my 1991 chrysler lebaron. How do I...

deileenk53 · #1 (**permalink**) 1st January 2008, 07:05 AM

...loosen the tension pully? There is one bolt just behind the pully that looks to be the one I am looking for, but turning the bolt does not seen to loosen the pully. Any suggestions? Thanks.

frydaddy · #2 (**permalink**) 1st January 2008, 10:50 AM

most of the time they are a springed pulley put wrench in center and move away from belt

jack w · #3 (**permalink**) 1st January 2008, 07:20 PM

Loosen the pully bolt so that the pulley can move up and down then back off the adjusting screw. good luck

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode